#11
|
||||
|
||||
Carl,
I'm re-thinking the pylon skins to eliminate having to burn anything, plywood or paper. Since they're just skins, they could be simply cardstock, or something just slightly thicker. I'm going to try some simple posterboard (WalMart grade) for the first prototype. Attached below is a revised set of balsa cutting patterns, using the information you gave. I'm setting the tiny hold-together tabs at a nominal width of 0.03". See if this comes closer to your laser's needs.
__________________
Craig McGraw BARCLONE Rocketry -- http://barclone.rocketshoppe.com BARCLONE Blogsite -- http://barclone.wordpress.com BARCLONE Forum -- BARCLONE Forum BARs helping BARs SAM 0044 AMA 352635 Last edited by CPMcGraw : 09-30-2010 at 02:18 PM. |
Thread Tools | Search this Thread |
Display Modes | |
|
|