After seeing it, I thought I would try a cardstock version. I have my original done (with plenty of mistakes). I'm hoping someone else can build it to see what else might need changed.
___

Attached Files

	Razorback_Prototype_01A.pdf (134.2 KB, 48 views)
	Razorback_Prototype_02A.pdf (1.44 MB, 27 views)
	Razorback_Prototype_03A.pdf (48.3 KB, 23 views)

I have an updated version but waiting for someone to try the prototype.

I fixed some issues and added a larger tube support to fit lower in the fuselage.
___

Cool. I'm not a cardstock guy, but just wanted to say well done.

__________________

I have a final version done. Far from perfect but should work. Designed for tumble recovery and will need some nose weight.

Found it is easier to install the upper tube support without one of the engine panels since it ends up in the same spot. Could leave off the engine panel tabs if you use the lower tube support. Then figure out how to add fins near the yellow thrusters.
___

Attached Files

	Razorback_Final_01A.pdf (135.7 KB, 15 views)
	Razorback_Final_02A.pdf (736.1 KB, 14 views)
	Razorback_Final_03A.pdf (111.5 KB, 13 views)

Here is a finished build, minus the tube.
___

Attached Thumbnails