Gentlemen, I just now slit open a Quest Aerospace Harpoon #3008 and I laid out the parts for assembly prep.

The (2) balsa sheets are (2) different thicknesses and its been a while since I built a #3008 but IIRC they’re both supposed to be the same thickness. The sheet with the swept, middle fins (part E of the kit) is 3/32” and the sheet with the Nike-style bottom fins and the small top strakes (part F of the kit) is 1/8”. I don’t remember which thickness is correct for all of the fins.

Thank you!

__________________
Never trust an atom. They make up everything.

4 out of 3 people struggle with math.

Chemically, alcohol IS a solution.

NAR# 94042
SAM# 0078

All three sets of my Harpoon fins are 1/8" thick.
This was built several years ago.

__________________
I like the unusual, the off beat, the avant-garde. No 3/4 FNC for me!

That’s what I thought. Thanks!

__________________
Never trust an atom. They make up everything.

4 out of 3 people struggle with math.

Chemically, alcohol IS a solution.

NAR# 94042
SAM# 0078