#1
|
||||
|
||||
Bomarc Scratch Build
I'm currently building a Bomarc based on a BT-60 tube. The ramjets are made from BT-55 balsa nose cones and do add some significant weight to the model. Here is my quandary........the ramjets are going to move the CG off the line of thrust. Should I be concerned that the rocket is going to arc over and lawndart? If that IS a concern, any suggestions as to how I get the CG back in line with the thrust (without adding excessive weight)?
Joe |
#2
|
||||
|
||||
Use uncentering rings which mount the motor tube off center.
Bill
__________________
It is well past time to Drill, Baby, Drill! If your June, July, August and September was like this, you might just hate summer too... Please unload your question before you ask it unless you have a concealed harry permit. : countdown begin cr dup . 1- ?dup 0= until cr ." Launch!" cr ; Give a man a rocket and he will fly for a day; teach him to build and he will spend the rest of his days sanding... |
#3
|
|||
|
|||
Quote:
So far has not been a problem on the NCR/Estes Bomarcs, even on the 3in version. |
#4
|
|||
|
|||
Be REALLY careful when trimming the rocket for different motors.
http://www.rocketreviews.com/empire...chelberger.html
__________________
Bill Eichelberger NAR 79563 http://wallyum.blogspot.com/ I miss being SAM 0058 Build floor: Estes - Low Boom SST Semroc - Marauder, Shrike, SST Shuttle In paint: Canaroc - Starfighter Scorpion Centuri - Mini Dactyl Estes - F-22 Air Superiority Fighter, Multi-Roc, Solar Sailer II, Xarconian Cruiser Semroc - Cyber III Ready to fly: Estes - Solar Sailer II Semroc - Earmark |
Thread Tools | Search this Thread |
Display Modes | |
|
|