The two nose cones are not interchangeable. I have a reverse Astrocam set up with a length of Quest T-35 tubing and a Quest PNC-35 nose cone. I had to shim the base of the T-35 a bit so that it would fit the ST-13 (BT-56) shoulder of the Astrocam snugly.

__________________
'Til next time,

Mike Toelle

NAR 31692 L1

SAM 0373

Druziv:

The attached .pdf is a listing of the major pieces necessary to clone the basic EnerJet fleet with their Semroc part numbers. Anyone on this website can add their own recovery parts. I'm not sure eRockets recognizes the importance of these parts; some may be discontinued.

Attached Files

ENERJET CLONING.pdf (32.8 KB, 46 views)

__________________
NAR 79743
NARTrek Silver
SAM 062

Awaiting First Launch: Too numerous to count
Finishing: Zooch Saturn V; Alway/Nau BioArcas; Estes Expedition
Repair/Rescue: Cherokee-D (2); Centuri Nike-Smoke; MX-774
On the Bench: 2650; TLP Standard
Dream Stage: 1/39.37 R-7

Well dang. I was hoping it would be an equivalent because I have several old Eagle/Falcon kits stored away. I may still dig one out and see how close the NC profile is. The clones wouldn't be an exact 1:1 if you had to shim, but if the NC profile is the same, nobody would notice without a direct comparison.

__________________
I love sanding.