#1
|
||||
|
||||
A Product I'd Like to See...
Hi Carl,
I recently made 2 of the cradles that are shown on page 33 of the 7th. edition of the Handbook of Model Rocketry. Not really difficult but a bit time consuming. I used some HARD left-over balsa that wasn't really good for much else. Any possibility that you could produce laser - cut kits of these? I know that balsa is at a premium; maybe it'd be a good way to use up some less than ideal balsa. 2 - 3 sizes to start? Many thanks in advance, Bob
__________________
illegitimi non carborundum NAR# 54643 L-1 SAM# 043 AMA# 157091 VRCS# 154 A&P# 42x xx xxxx. |
Thread Tools | Search this Thread |
Display Modes | |
|
|