#1
|
||||
|
||||
A Product I'd Like to See...
Hi Carl,
I recently made 2 of the cradles that are shown on page 33 of the 7th. edition of the Handbook of Model Rocketry. Not really difficult but a bit time consuming. I used some HARD left-over balsa that wasn't really good for much else. Any possibility that you could produce laser - cut kits of these? I know that balsa is at a premium; maybe it'd be a good way to use up some less than ideal balsa. 2 - 3 sizes to start? Many thanks in advance, Bob
__________________
illegitimi non carborundum NAR# 54643 L-1 SAM# 043 AMA# 157091 VRCS# 154 A&P# 42x xx xxxx. |
#2
|
||||
|
||||
Quote:
__________________
Black Shire--Draft horse in human form, model rocketeer, occasional mystic, and writer, see: http://www.lulu.com/content/paperba...an-form/8075185 http://www.lulu.com/product/cd/what...of-2%29/6122050 http://www.lulu.com/product/cd/what...of-2%29/6126511 All of my book proceeds go to the Northcote Heavy Horse Centre www.northcotehorses.com. NAR #54895 SR |
#3
|
|||
|
|||
Quote:
If I get a chance tomorrow I'll post a picture or two of the cradles I made from Baltic Birch Plywood from the handbook. . I used 1/8" and 1/4" ply. length are about 6" and 12" I ordered the plywood from www.sloanswoodshop.com located in Lebanon, TN John
__________________
John NAR #91135 L1 SAM #0037 |
#4
|
|||
|
|||
Yea, that would be neat to have.......Carl, I'll buy some. And they'd be easy for you to produce and not take away from other cool things you are working on.
__________________
Dumpster Diver |
Thread Tools | Search this Thread |
Display Modes | |
|
|