#1
|
||||
|
||||
Estes Vagabond rocket #1423
Estes Vagabond rocket #1423 (starter kit) - Anybody know the BT length and type, and NC type for this rocket?
Thanks, |
#2
|
||||
|
||||
Quote:
It's the same kit as the Centuri / SEMROC Astro-1. Body tube is ST-10 (1.04" diameter), and I believe the nose cone is the long 5.2" version. SEMROC has the kit available with laser-cut fins. The only (important) differences between the Estes version and the Centuri version are the paint scheme and whatever decals might have been included.
__________________
Craig McGraw BARCLONE Rocketry -- http://barclone.rocketshoppe.com BARCLONE Blogsite -- http://barclone.wordpress.com BARCLONE Forum -- BARCLONE Forum BARs helping BARs SAM 0044 AMA 352635 |
#3
|
|||
|
|||
Are you certain this was ST-10 based ? and not 'updated' to BT50 ?
I'd like to clone this one myself, always thought it was BT50 based, as catalog photos do look like PNC-50YR. Inquiring minds...... ~ AL |
#4
|
|||
|
|||
I built the original a couple of years ago and I am sure it has the Bt-50 and the two piece PNC-50 YR nose cone........The body tube is the Bt-50W...9.5 inches
|
#5
|
||||
|
||||
Quote:
Ya know, that was one of those "woulda - coulda - shoulda" moments when I hit the 'SEND' button... I thought the catalog page indicated the larger diameter of ST-10, but if sigs30 has built one and says it was BT-50, then I'll defer to his hard evidence. I just went back to Ninfinger and looked at the only two catalog entries (1989 and 1990) where the model was listed, and neither actually indicate the diameter - just a length of "over 16". So much for presuming... I need to update the Extended Kit List now. The body tube size is listed there as ST-10. My thought was Estes was still 'burning off' some excess stock from the pseudo-merger with Centuri... BTW -- Nice build, sigs!
__________________
Craig McGraw BARCLONE Rocketry -- http://barclone.rocketshoppe.com BARCLONE Blogsite -- http://barclone.wordpress.com BARCLONE Forum -- BARCLONE Forum BARs helping BARs SAM 0044 AMA 352635 |
#6
|
||||
|
||||
Thanks to the both of you for clarification on the build specs.
ron |
#7
|
|||
|
|||
Scigs did you possibly scan those decals? If so could you possibly post them?
Thanks Bob |
#8
|
||||
|
||||
Quote:
I can confirm what Scigs reported - the airframe is indeed a BT-50W, 9.5" long, and the nose is none other than the ubiquitous PNC-50YR. I've scanned my decal sheet and have sent it to Scott (can't post it here as it's too large); perhaps he can make an emergency upload to the plans site. Scott - I can provide a scan of the rest of the instructions, etc, if you need them.
__________________
John YORF #003 SAM #004 |
#9
|
|||
|
|||
Sorry I didn't post the decal, I see YORS has the decal and plan scanned.
|
Thread Tools | Search this Thread |
Display Modes | |
|
|