#41
|
||||
|
||||
Alternate to Solid Cone
I took measurements of my cone with only slight differences, probably due to warping. I had also offered my cone and luckily it was not needed - it is too brittle and has a repaired crack anyway.
I had planned to make a three piece component to replace the cone, maybe this can be incorporated into plans for a new turning. The bumps and other reliefs will be cut from craft foam sheets, once I make a template, that will be glued part as a wrap to the cone and as detaling. My first attempt bombed and I gave up, but now with renewed interest, and the skills of other YORF artist, I think it will be done. correction - picture lists part as HTC-55 (no such part at SEMROC) Hollow tube coupler is JT-55 two needed and to be trimmed since only 1.5 inch Last edited by Bob Thomas : 01-21-2010 at 02:05 AM. Reason: correction |
#42
|
||||
|
||||
OK, now this drawing was freakin' harder than the first one!
__________________
"I'm a sandman. I've never killed anyone. I terminate runners when their time is up." Logan from "Logan's Run" http://sandmandecals.com/ |
Thread Tools | Search this Thread |
Display Modes | |
|
|