#1
|
|||
|
|||
BT-50 to BT-20 Boat Tail / Tail Cone
This is a 3D model of a boat tail / tail cone for rockets meant to fit BT-50 airframe tubing.
This is modeled closely for the Estes Sprint (kit# K-49/#1249). There are two versions - one that is plain and one with a tunnel to allow for a motor retainer clip. https://www.thingiverse.com/thing:4764379 |
#2
|
||||
|
||||
Nice! I was never very good at paper transitions.
|
#3
|
|||
|
|||
I did some test prints and found there were some problems with the design. I re-designed one, test printed it, made more corrections, and finally came out with a print I liked. I re-designed the rest and added a few more versions.
|
#4
|
|||
|
|||
great work Jack!
__________________
"Old Rocketeer's don't die; they just go OOP".....unless you 3D print them. |
Thread Tools | Search this Thread |
Display Modes | |
|
|