Not the best rendition of a lander, certainly, and I think this could use lots of extra detailing, but here's my simple lander craft for SEMROC Series-20 tubes. Note that the nose cone shown here is not an exact size match to any of Carl's NCs, so just match up the next nearest elliptical and change the length figure in the file. The final numbers should be close.

The legs are made up from spruce dowels, 3/16" diameter, and balsa sheet stock, also 3/16" thick. Without getting more complicated, I drew the legs as a single piece.

Length: 17.49"
Diameter: 2.04" (Large Series 20)
Fin Span (legs): 8.9"
Weight: 2.79 oz

C6-3......410'......Dv 9-11 FPS......48" rod 3/16" dia

Enjoy!

Attached Thumbnails

   

Attached Files

Titan Lander.rkt (111.0 KB, 108 views)

__________________
Craig McGraw

BARCLONE Rocketry -- http://barclone.rocketshoppe.com
BARCLONE Blogsite -- http://barclone.wordpress.com
BARCLONE Forum -- BARCLONE Forum

BARs helping BARs

SAM 0044
AMA 352635