I've found JimZ's scans, but w/o a scale, the printout is dubious. I've found a .rkt file on rocketreviews, but if the fin placement is "right" the fins are too large (backed up by my printout of JimZ's pattern). I've found so many errors in .rkt files from there, I always try to double check the info found there.

Anyone got a set they can scan w/a ruler so I can get accurate info?

Thanks!
Jim

__________________
.
.

Dreaming of making the rockets I dreamed of as a kid (and then some).

"The Guide says there is an art to flying", said Ford, "or rather a knack."
"The knack lies in learning how to throw yourself at the ground and miss."

Launching is Optional... Landing? That Depends on Trees.

The root edge of both fin sets is 5". The main fin is 5" across at the widest point. The forward fins set is 1" wide at its widest point. The balsa is 1/8" thick. Note that these measurements were taken from a built model. Hope this helps.

__________________
'Til next time,

Mike Toelle

NAR 31692 L1

SAM 0373