04-08-2008, 10:21 PM
|
Master Modeler
|
|
Join Date: Dec 2005
Location: Washington State
Posts: 654
|
|
New Design: Sky Champ
Here is another variation of a Lander I came up with called the Sky Champ. It uses an
BnC-55BE as a nose cone and the main body is shaped by using an BTC-70HZ hollow balsa
transition. I cheated the Static Margin reference for this file as I felt the Maximum Frontal
Diameter is too much for this short wide design.
I also added for extra drag at the bottom of the landing legs some CR-7 kockouts of
Carl's .05 cardstock to look like landing pads. I always save these and know I finally ahve a
purpose fro them. I don't know how to sim the drag for the landing pads so I will leave it up
to Jay to fiqure that out. These pads may just be the thing needed to fix the Neptune Lander
CG-CP as well.
Enjoy and Thanks Again, JP
Sky Champ (18mm)
Launch guide length: 36.0000 In
MOTOR.................MAX. ALTITUDE...........DEP. VELOCITY
1/2A3T-2..............70.68996 Ft..............4.7838 ft/s.
A10T-3................204.79724 Ft.............7.3262 ft/s
James Pierson
NAR# 77907
.
|