03-05-2021, 07:33 PM
|
|
Old Submariner
|
|
Join Date: Jan 2009
Location: Home of Wayne & Garth
Posts: 7,772
|
|
The 29mm engine mount.
The LOC engine mount tube that I cut to 8" long wouldn't go into the male threaded engine lock ring without a great amount of sanding. Using 120 grit I sanded the tube--rather than the 3D printed ring so as not to weaken the ring. After I achieved a slip-fit I mixed up more 30 minute epoxy and assembled the engine ring, the rear CR (at top,) and the forward CR (at bottom.)
TBC
__________________
Never trust an atom. They make up everything.
4 out of 3 people struggle with math.
Chemically, alcohol IS a solution.
NAR# 94042
SAM# 0078
|