Thanks y'all.
The fin can weighs 5oz.
I though I have to put a thrust ring inside the motor tube?
The retention for the center motor is the screw on type.
Without a thrust rig will the motor not just shoot up the tube?
Or are you thinking friction fit motor.
Could I not just figure out the length of the longest motor I will use and use motor blocks
for smaller motors.
Just have a lot of questions. I have only built Estes and Quest models out of the box.
This is my first time attempting customizing.
Alex at Boyce told me to weigh the rocket without motors after balancing and he could give me some motor options.
I don't know if any of y'all have used them, but the after sales service has been outstanding.