04-20-2006, 04:30 PM
|
|
Craftsman
|
|
Join Date: Mar 2006
Posts: 457
|
|
Aren't the fins from the Eggspress the same as the EggCrate?
I have 2 of the Eggspress kits opened. The fins were die-punched.
Should I post a jpeg of them with dimensions or are you set already?
Also, where did you find that RED fin can?
Or did you paint it that way.
I was playing around with the Semroc balsa part equivalents last nite.
The 1340/20 clone is WILD when you replace both the #13 and #20 tubes with 34" long pieces!
It should cruise slow and sweet on an E9!
Interesting note---- the yellow plastic cone and transition weight LESS than the balsa equivalents.
Without motor mount and recovery device, the complete mock-up of plastic weighed 94 grams where the balsa came in at an even 100 grams.
|