Again I slide the assemblies apart and using the leather punch I punch (2) 3/32" holes into base disk of the BT100. I then place the bottom shoroud onto the bottom and the nozzle (no glue) and trace it's edge. I then use the inside cartridge of a ballpoint pen and mark the inside of the bottom disc of the bottom wrap for locations of the screw bosses. TBC

Attached Thumbnails

       

__________________
Never trust an atom. They make up everything.

4 out of 3 people struggle with math.

Chemically, alcohol IS a solution.

NAR# 94042
SAM# 0078