01-07-2019, 09:40 PM
|
BAR 13790
|
|
Join Date: May 2008
Location: Johnson City, NY
Posts: 525
|
|
Well, I hope everyone is happy with my messy workspace...
Something else I plan to change. There are 3 pod tubes, each 12" long for a total of 36". If I use the 2.25x scale they should be 40.5" long. I have a spare 29mm motor tube. So I am going to use the supplied tube and cut it into 3 sections of 4" each. Adding these to the supplied tubes will give me a total of 40" - close enough.
I also am concerned about fitting this thing into my car, so I would like to be able to separate it - only adds to the challenge of ducting the ejection charge.
Along with the replacement cones, I got a 34" long section of coupler tube from eRockets which I cut into 3 pieces. The plan will be to glue one end in and be able to slide the other end over and secure the tube to the coupler (probably with screws)
|