Alignment will be important in this model, so I've penciled witness marks onto the bottom disk and the body tube.

I then make pencil marks on the bottom disk to mark the outer edges of the landing gear housings, transfer the marks up the sides of the base, and into the edge of the base cavity.

I then slit a 1/2" wide strip of 3/16" thick basswood ("The Vixen" was able to get the bleeding stopped) and scrape a slight convex profile into one side of it with the Corian slab sovered with 220.

To help prevent the 3/16" basswood from splitting during it's end use, I slit a strip of .040" styrene and glue it onto the flat surface of the basswood strip with thick CA and clap it in place with clothespins. I use CA VERY rarely in rocket construction. I'm using it in this case only because of the dissimilar materials.

TBC

Attached Thumbnails

             

__________________
Never trust an atom. They make up everything.

4 out of 3 people struggle with math.

Chemically, alcohol IS a solution.

NAR# 94042
SAM# 0078