05-20-2022, 12:29 PM
|
Craftsman
|
|
Join Date: Aug 2018
Posts: 274
|
|
Here is the result of the prints. Took about 40 minutes to print.
The first picture (Finished Print.jpg) shows the prints completed. Need a bit of cleaning - especially the nose. Might be able to reduce this by slowing down the print and increasing retraction slightly.
The second picture (Cleaned w Original.jpg) shows the parts after they had been cleaned up (top of the picture). I did end up breaking one of the nose fins off. Need to make sure you have a sharp knife and take your time. The original parts are at the bottom for comparison.
The third picture (Body Added.jpg) shows the 3D prints added to a 1/8-inch launch lug. The bottom part of the picture shows the original parts added to a 1/8-inch dowel.
Overall I was very happy with how these prints turned out. Small parts can be tricky on a FDM 3D printer.
Hope that helps.
|