08-08-2007, 08:38 PM
|
Master Modeler
|
|
Join Date: Dec 2005
Location: Washington State
Posts: 654
|
|
New Design: Nebula
This particular design called Nebula, and I have redone it several times. The forward fin set on this design does not help the margin much. I finally can up with a way to add clay nose wieght without drilling the nose cone. Clay can be added by cutting the main BT 1.5 to 2 inches aft of the BNC and add a balsa tube coupler at this joint. The clay can be added in the hollow BT section between the BNC coupler and the Balsa Tube Coupler . The 2D drawing might help better explain this method .
This design is inspired by a vintage sci-fi magazine cover called Nebula issue #27. It is an 18mm design and falls in the VR class of designs. All Semroc parts have been used.
Enjoy and Thanks Again, JP
James Pierson
NAR# 77907
|