11-01-2006, 07:42 PM
|
|
BARCLONE Rocketry
|
|
Join Date: Mar 2005
Location: Mobile, Alabama
Posts: 5,357
|
|
Fin Pattern -- Andromeda
Here's the templates for the Andromeda fins. Be careful when cutting the slots for the shrouds, as this is a tricky fit. You may need to assemble the fins first, then cut the fins across the whole assembly even with the inside diameter of the shroud, and finally trim out the shroud areas from the outer fin section before gluing it back in place. Use 1/8" hardwood dowels for the connectors in the tips and intermediate stretchers.
Addendum: I did not show the notch for the HTC-7B coupler used to hold the engine hook in place, as some might not want to include a hook and just go "friction fit". Personally, I'd use the hook...
|