09-06-2020, 08:42 PM
|
|
Semi-Pro Rocketeer TRA 10484 L2
|
|
Join Date: Apr 2007
Posts: 428
|
|
Hello rocketeers,
I wanted to type a update to this. I went back to the Red Solutech filament and cut about 18" off the start of the roll and refeed it into the printer and had zero problems printing with it at the same settings I've been using for everything. 200C x 60C x .20Z settings. I have also moved to 65C for bed temp, items stick a little better to the bed with no bad side effects.
So I would recommend cutting of 12 to 24" off a new roll before using it. I noticed that the filament can have small kink or two in it when new which can cause feed problems.
Thought I would mention this, since I noticed this on a color change over and it made all the difference for me
Happy printing
__________________
=======================
If the Sky is the Limit, then,
why is there Footsteps on the Moon?
=======================
|