08-22-2020, 02:55 PM
|
|
Semi-Pro Rocketeer TRA 10484 L2
|
|
Join Date: Apr 2007
Posts: 428
|
|
Solutech Red Filament Problem
Ok, I did some checking online and the Red filament from this company was singled out as being a problem for at least two people. Counting me, that makes 3. I Printed Phil the Astronaut with Creality Filament with no problem at all. I decide to try the Solutech Blue roll that I brought. Again, no problem at all, it's feeding through the Extruder just fine and is printing great using the same settings that I used for the Creality. 200C Nozzle temp and 60c bed temp with Z axis setting of .20 above print bed. I'll give the Red Solutech a try at later time.
__________________
=======================
If the Sky is the Limit, then,
why is there Footsteps on the Moon?
=======================
|