12-18-2011, 07:18 PM
|
|
BARCLONE Rocketry
|
|
Join Date: Mar 2005
Location: Mobile, Alabama
Posts: 5,357
|
|
After looking at the photo of the fin sheet on Leo's site, I thought everyone might appreciate having a "Krellvenator Pattern" for cutting a set of four fins...
The plans on Leo's site show a "normal looking" fin tip, but the sheet in his photo set clearly shows a tip extension. Since the sheet appears to be inked only, and not die-crunched, one presumes the builder would cut the fin to match that shape. So, I'm leaving that tab in place for nostalgia.
Hope this helps!
ADDENDUM: The files have just been corrected. Spotted an error in the line layouts.
|