01-31-2011, 10:07 PM
|
|
Master Modeler
|
|
Join Date: Jan 2009
Location: Fairbanks, Alaska
Posts: 6,507
|
|
Quote:
Originally Posted by Blushingmule
Hi Carl,
I recently made 2 of the cradles that are shown on page 33 of the 7th. edition of
the Handbook of Model Rocketry. Not really difficult but a bit time consuming.
I used some HARD left-over balsa that wasn't really good for much else.
Any possibility that you could produce laser - cut kits of these? I know that balsa is
at a premium; maybe it'd be a good way to use up some less than ideal balsa.
2 - 3 sizes to start?
Many thanks in advance,
Bob
|
And if not balsa for any reason (due to its relatively high cost, or perhaps they do already have other uses for the non-premium balsa stock), how about cradles made of laser-cut beveridge board (the paper industry's name for "fiber fin stock")?
|