Those are the results from the second prototype A1.5-0 10mm engine! A little too hot for an A, but that was improved with third which was 2.50N 1.51N and 1.66s. There still is .6" left over in the tube for delay and EC. That will probably limit a full A to about 6 seconds max.

The thin wall cases do hold up. I was afraid that since they are about .050", they would cato or burn-through. So far, all the tests are positive.

An old Estes A8-3 on the stand was 2.2N-s with a .52s burn.

There is still a lot of work to do!

Attached Thumbnails

 

__________________
Carl McLawhorn
NAR#4717 L2
semroc.com