01-13-2007, 11:22 PM
|
|
Incurable SEMROC Fan
|
|
Join Date: Mar 2005
Location: Twin Falls, Idaho, USA
Posts: 2,319
|
|
Preview: "Tau Zero" Fin Guides
Quote:
Originally Posted by John Brohm
I said all of that to say this: it would seem to me that Carl could generate an extremely accurate and comparatively inexpensive family of fin alignment templates with his laser cutter
|
Yeah, he's, uh (cough) workin' on it. (See photo below.)
Quote:
I find that the fin slots in the template have to be just a slight tad over-size so that the template will slide on without any binding.
|
I was thinking just today that I need to go down to the tool store and pick up some Dial Calipers to determine what the tolerance should be, since the prototype guides below fit *real* (i.e., "too") snugly.
We need to cut some "triangles" to allow room for the fillets, so the fin guide doesn't get glued to the rocket.
Cheers,
__________________
Jay Goemmer
"Centuri Guy"/"Tau Zero"
YORF Member 28
Semroc SAM #0029
NAR 86131
"I think about organizing things all the time. Never seems to happen. I find something that piques my interest and I'm off on a quest. Or a Centuri. "
--Bill Eichelberger, 02/22/2022
“Centuri fret buzz in an updated form.”
Bill “Wallyum” Eichelberger re: Estes Flutter-By
03 Sept 2014
|