07-12-2008, 04:22 PM
|
|
BARCLONE Rocketry
|
|
Join Date: Mar 2005
Location: Mobile, Alabama
Posts: 5,357
|
|
New Plan -- Wave Rider Boost Vehicle
Here's a 13mm power pod for launching the Wave Rider as a glider. Remember, as a glider, the Wave Rider should have no motor mount.
Locate the CP on the glider, and position it directly above the "sleeve" shown at the CP location of the pod. This keeps both CPs together for the boost phase.
Mount a short piece of launch lug on the step of the upper fin on the pod. Similar to that found on the Orbital Transport orbiter, position a hold-down dowel on the bottom of the Wave Rider so that it aligns with the lug.
Remember to trim the glider for a stable flight, using trim tabs. Adjust the balance point with clay, as needed, to produce a modest straight-line glide with only a gentle loss of altitude.
Also remember, this is yet to be flight-tested...
Enjoy!
|