This step I show how to connect the cones to each other to complete the warhead section.

1st step is to put glue on two of the tabs nearest to the glue seam. Align all glue seams to form a straight line.

Reach inside with a finger to pinch the glue into the paper with another finger on the outside pressing down real hard. Must hold this step until the glue tacks solid. Very important to hold until set. This joint will come apart during the next step, if you don't hold long enough. If it comes loose, this will cause severe frustration, trying to get it re-glued over the old glue.

The glue will not get into the cardstock fibers, but glue to the ld glue, this doesn't make a very solid/strong connection.

Please hold/pinch this beginning glue joint longer than you want to!

No photo of the pinching operation, only two hands and both are needed for the pinching.

Attached Thumbnails