View Single Post
  #33  
Old 01-26-2008, 06:51 PM
James Pierson James Pierson is offline
Master Modeler
 
Join Date: Dec 2005
Location: Washington State
Posts: 654
Thumbs up Looks Good Jay.

I really like this design Jay. This one get my vote for your next kit release . I you don't like the fin standoff amd the launch lug placement concider the following.


Cut that LL330 in half or just use two LL320 launch lugs.
One LL on the upper body tube and the other on the side of an large fin.
You end up with an Upper LL and an Lower LL. (Lower LL in rocksim Make Inside Tube)
One drawback to this is a launch rod is needed for alignment during assembly .

Once again Jay, Great Design!

Your Pal, JP

James Pierson
NAR# 77907
Reply With Quote