Tim (morley)-

Thanks for sharing your experiences here with the rest of us. I have wondered where Leo had run off to in recent years...sounds like he is spending his time on that OTHER forum....

Anyway, yes, your first-hand expereinces are just the kind of reports I have been wanting to read before jumping in myself. As tbzep said, I've been waiting for ease of use and, frankly, quality of output, to improve before jumping in. Even some of the stuff offered for commercial purposes, while improving, is still just a bit on the rough side for my personal tastes; but that is just me. But...it is getting better for sure. The photo of your Pershing fin looked great.

I really need to just purchase a commercial kit or part or two and do some full finish work on them to see just how much sanding, filling, and priming are necessary to get a good, quality finish on these parts.

Share more as you go, if you so desire. I suspect there are many here who want to learn and see more.

Thanks again.

Earl

__________________
Earl L. Cagle, Jr.
NAR# 29523
TRA# 962
SAM# 73
Owner/Producer
Point 39 Productions

Rocket-Brained Since 1970