I've been working on/thinking about this one for a while, I found a spare cosmic interceptor kit in my box that wasn't allocated to kits, and put this together. Based on an F-16, of course with a longer nose due to the interceptor cone. I went with a mid mounted wing and full flying tail only. I had to cut off one of the speed brake tabs on one side so that I could slide the wing in the slot, then glued it back in place, then slide the stabilators on and glued on the capture rings to hold them in place. Did some glide tests in the house before equipment install and took a swag at the boost CG. RTF weight came out right at 11.25 ounces before finishing. Did two test flights today in about 10mph winds, handled it really well, and I was able to move the CG back slightly.

I started using some vinyl to do the markings and so far she is coming out pretty nicely. I had to modify the thunderbird scheme slightly since I'm cutting this freehand and the nose being long, I did some nose and mid stripes so the middle wouldn't seem too plain. It's about half done with markings and panel lines, but with the bird on the bottom complete.

Attached Thumbnails

     

__________________
RC Rocket glider kits
www.dynasoarrocketry.com