01-02-2021, 04:17 PM
|
Craftsman
|
|
Join Date: Aug 2011
Location: Washougal Washington
Posts: 375
|
|
Being an E2X-equivalent, it's basically done now. The nose is already painted, and only the decals remain.
But, on my prior builds, I goofed the positioning a few times. That adhesive grips immediately, and if you try to move it, it lifts the silver coating on the tube.
This time, I used the drop of soap in the water trick. I mixed up a small amount of water with a drop or two of shampoo. Before applying the decal, I wetted the back of it with the soapy water. I also spread a thin layer of soapy water on the body tube where the fin was to go. This film gave me a small opportunity to position the decal before it stuck hard. When it was in place, I wiped down the decal with a towel, squeezing out the water and letting the adhesive bond to the paper tube.
|