New Design: Magic Circle
 

Well, the fit on this tube fin/ ring fin design, called Magic Circle, seems to fit in the Rocksim 3D world. The main BT is an ST-8 tube with 4 ST-13 tube fin which are all surrounder by and ST-3630 ring fin. If ya plan to build this one, put in a fresh X-acto blade as the ST-13 (1 inch long) and the ST-3630 (1/2 inch long) are custom length tubes. Watch out for that ST-3630 tube cutting, it's fairly thick tube (.09) and will take several times around to get it cut thru.

Enjoy and Thanks Again, JP.

James Pierson
NAR# 77907
.

???ST-3630??? What is that?

MarkII

It's the "Ring Fin" off of the Hydra VII.
http://www.semroc.com/Store/scripts...p?idproduct=246

That's a really clever design. although I was expecting to see more do dads on it as it is a bit on the plain side for you James. :chuckle:

Just kidding, I really like the simpleness of it.

.

Thanks Ray.
It may not be fancy ;) , but it still counts as an design for the count as we are approaching 700. Besides, I am not real sure of the fit of the tubes. Only being built will tell if Rocksim is correct in the 3D view.

James Pierson
NAR# 77907