Estes Executioner
 

Anybody got the dimensions of the fin set for the Estes Executioner?

as side questions:

1. anybody do body tube slotting
2. anybody laser cut fins ?


anybody know the length of the 2 BT-80 body tubes ?

length of fin slots? and location from rear?

I hate these new Estes Rocket plans with no dimensions of anything.
tia

Terry

I have a set I don't plan to use. You're welcome to them. I might also have a decal set if you give me a day to safari for it.

Toby Vanderbeek does clones of Estes kits, and upscales -- he buys nose cones and tubes from Estes, then laser cuts the fins and CRs. He has you go to Stickershock23.com for the decals. He has a Mega Der Red Max, a Leviathan, a Hi-Flier XXL, and Cherokee-H, and now, Goblin fins (some guys in my club are ordering TTW Goblin fins and flying their beefed-up Goblins on F44s ... :)

He also does custom work. I have not ordered from him, but he gets high praise for his work. I would imagine he could slot tubes for you, it probably just depends on if he has the tubing you want in stock, or has to get it.

He was just on FB, but now has a werbsite. https://www.vander-burn.com/

Both tubes measure 14". If Bill can't find you a decal then I have several you're welcome to.

I got lucky and got 2 retail kits so I can use them to id the parts needed for a clone.....thanks everybody

You could always redress a LOC Graduator in Executioner livery - as long as you build it fairly light it should work with adapted E12s - tube is already slotted. Then you could use Estes oh so much fun 29mm BP motors now that they’re back in production.

If anyone needs the fin set, just let me know. :cool: