#11
|
|||
|
|||
Quote:
How do we find out which files you are wanting, Carl? Is there someplace on your site that lists what you are needing? James |
#12
|
||||
|
||||
Quote:
I've got a boatload (and then some) of fin patterns drawn up in Adobe Illustrator, which I think CorelDraw! can import. I could easily send them along assuming they would work. |
#13
|
||||
|
||||
Quote:
Quote:
Carl, I was thinking the same thing. Maybe a simple chart could be worked up in Excel containing all of the patterns you're looking for, with a cell to indicate which patterns you have received, and which patterns you would like us to concentrate on more than others. As a pattern is finished (after you've cleaned them up, or after you've received them) place a check mark (or a big "X") in that cell. Then you can simply generate an HTML file of that chart as needed and post it on your website in the SVDT area...
__________________
Craig McGraw BARCLONE Rocketry -- http://barclone.rocketshoppe.com BARCLONE Blogsite -- http://barclone.wordpress.com BARCLONE Forum -- BARCLONE Forum BARs helping BARs SAM 0044 AMA 352635 |
#14
|
|||
|
|||
Carl,
Just curious - any possibility of getting into laser-cut ply fins (something like 1/8" or 3/16") with the laser cutter? I dont' mind cutting balsa at all, but ply is a pain in the rear...it could be a valuable service if getting the file imported was not time consuming - such as requiring a TIFF file (based on your earlier comments). I don't know about others - but I would be much more likely to order a bunch of stuff if I knew that I was getting out of cutting plywood fins. Thoughts? thanks |
#15
|
||||
|
||||
The thickest hard ply we can cut without charring is 1/16". The 1/8" lite ply cuts well, but it is not good for fins.
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
#16
|
||||
|
||||
OK, Carl, I finally got my order in.
Thanks again! - Eric |
#17
|
||||
|
||||
Eric,
I sent the first set, but have not had time for the second. It takes a while to get rid of all the extraneous info and just get the cut vector.
__________________
Carl McLawhorn NAR#4717 L2 semroc.com |
Thread Tools | Search this Thread |
Display Modes | |
|
|