#1
|
|||
|
|||
A Question About the Estes Scion.
Hi Folks!
How important is it to install the "Spacer Ring C" next to the forward centering ring?
__________________
Roy Tuinila CMASS Member NAR #90252 NARTREK Bronze L1 w/Mega Der Red Max on an H87-IM-7 |
#2
|
|||
|
|||
Probably adds a bit of support, and ensures alignment so the fin tabs fit in between the rings, but not super-neccessary. As long as your properly fillet the rings you should be fine.
The rear spacer ring is required to properly fit the motor retainer. Didn't realize that when I built an earlier PSII kit. FWIW, I used the suggested paint job on my Scion and it came out looking pretty spiffy.
__________________
NAR #27085 - Oregon Rocketry - SAM |
#3
|
|||
|
|||
Quote:
That it does!!
__________________
Up next: Under construction: Under repair: In finishing: Centuri Sabre clone In primer: In paint: Ready for decals: Bill Cooke NAR #31312 TRA #19705 SAM #0001 Huntsville, AL My rocket blog My rocket fleet |
Thread Tools | Search this Thread |
Display Modes | |
|
|