#1
|
|||
|
|||
Estes NASA Pegasus center of gravity
Does someone have an Estes NASA Pegasus they could check location of the Center of Gravity for me, please?
I'm working on a downscale, and planning on using 13mm Bs in it. I figure it could use some nose weight - but how much? If the original instructions list the Cg, I don't see it. Charles
__________________
Charles McGonegal Ciderwright AEppelTreow Winery & Distillery Ad Astra Tabernamque! |
#2
|
||||
|
||||
Personally, I would clone the kit and use the CG from it to figure out where it needs to be for upscales/downscales. Unfortunately, Estes generally does not give out CP/CG info on their kits.
Just my 2 cents.
__________________
'Til next time, Mike Toelle NAR 31692 L1 SAM 0373 |
#3
|
|||
|
|||
I suppose that would work. Or I could fetch my original back from my mother - she found it in the attic last year.
I had forgotten that Openrocket is attempting tube fins these days. I was reminded on the forum that shall not be named. OR suggests the Cp is a bit behind the leading edge of the wings. So the Cg should be near the front edge of the side tubes. Downscaling is fun - but I think it's prone to weight issues. This little fellow is going to take a bit of noseweight.
__________________
Charles McGonegal Ciderwright AEppelTreow Winery & Distillery Ad Astra Tabernamque! |
#4
|
||||
|
||||
The Estes kit is overtable by design.
|
#5
|
|||
|
|||
Very probably. But I suspect that the BT20 balsa nosecone is lighter (in proportion) than the plastic BT55 original. And I'm shoving a heavier motor in, too.
It should be minimally stable as I've built it, with a washer on the base of the nosecone. I hope to test that soon. The corn is off the fields!
__________________
Charles McGonegal Ciderwright AEppelTreow Winery & Distillery Ad Astra Tabernamque! |
Thread Tools | Search this Thread |
Display Modes | |
|
|