#1
|
|||
|
|||
Foam glider shipping frustration
So far I'm two for two, trying to order a Guillow's space shuttle via Amazon.
Is it hopeless? Will I always get one with one or more wing tips broken off? Shall I give up trying return/reorder and just repair one? I need one to go with the parts I ordered from Gordon :-)
__________________
Charles McGonegal Ciderwright AEppelTreow Winery & Distillery Ad Astra Tabernamque! |
#2
|
||||
|
||||
If the joint is clean I'd just glue it, if it is crushed that's a bit different depending.
Quote:
|
#3
|
|||
|
|||
It looks pretty clean. Not crushed, just snapped.
Any preferred adhesive, Frank, for the white expanded PS - the stuff that crumbles into little balls? I hav one of the Loctite 'foam safe' kits around here. One with a felt tip activator and something that looks vaguely like CA. It was the only foam safe I could find locally.
__________________
Charles McGonegal Ciderwright AEppelTreow Winery & Distillery Ad Astra Tabernamque! |
#4
|
||||
|
||||
I haven't used that, I've used bob smith super gold + thick foam safe CA, and bob smith foam cure, or beacons foam tac, the latter two are like contact cement, apply to both, pull apart, then pess together, or you can apply to one side and then hold in place, that's probably the best bet to make sure it makes a complete bond, it takes overnight to dry that way, but dries clear and flexible. The CA cures hard. a light bit of 5 minute epoxy should work fine too.
Frank Quote:
|
#5
|
|||
|
|||
Thanks for the suggestions. I've used contact cement and 5-min epoxy in the past, too. I find the epoxy seems to do a bit better with the uneven surfaces.
__________________
Charles McGonegal Ciderwright AEppelTreow Winery & Distillery Ad Astra Tabernamque! |
#6
|
|||
|
|||
So-called foam safe CA is terrible.
Epoxy is a much better choice. Allen |
Thread Tools | Search this Thread |
Display Modes | |
|
|