Did you make one for the next sod farm launch? I'll give you an E75.

__________________
www.wooshrocketry.org NAR Sec. 558
Look us up on YouTube: http://www.youtube.com/user/guytogo75?feature=mhee
unstable by design

Whats's minimum diameter on that motor? I can upscale something in Corel and see if it holds together

It's 24mm, same basic dimensions as a D12.

__________________
www.wooshrocketry.org NAR Sec. 558
Look us up on YouTube: http://www.youtube.com/user/guytogo75?feature=mhee
unstable by design

With that new HPR CERT LEVEL 1 (http://forums.rocketshoppe.com/show...98&postcount=1), CenturiKid could use something a bit bigger

Thanks for the info... I think I can pull together something you will like. Is this a single use motor? I wouldn't want to risk a case with what I'm thinking about attempting....

It's a reload, but the case is not expensive.

__________________
www.wooshrocketry.org NAR Sec. 558
Look us up on YouTube: http://www.youtube.com/user/guytogo75?feature=mhee
unstable by design

Here's a comparison of the two (minus aft closure).

Attached Thumbnails

 

__________________
www.wooshrocketry.org NAR Sec. 558
Look us up on YouTube: http://www.youtube.com/user/guytogo75?feature=mhee
unstable by design