|
|
Thread Tools | Search this Thread | Display Modes |
#1
|
||||
|
||||
New Scans Of The Quest Icarus (2006) Fins, Decals (along with a ruler)
Yes, I've seen the instructions and scans on plans.rocketshoppe/oldrocketplans.com problem is, those fins are clearly not unmodified scans of the originals (if they are, then they're the worst lasercut fins ever. Also the decals don't have a ruler to assure scaling.
If you have a built Icarus, a measurement of the width of the black wrap would also work to allow me to scale the decals. I'm hoping to get scans of originals along with a ruler for a new sim I'm working up. Thanks! Jim
__________________
. . Dreaming of making the rockets I dreamed of as a kid (and then some). "The Guide says there is an art to flying", said Ford, "or rather a knack." "The knack lies in learning how to throw yourself at the ground and miss." Launching is Optional... Landing? That Depends on Trees. |
#2
|
||||
|
||||
The fins on Quest kits in that era were die cut, not laser cut. I don't have that particular kit, but other Quest kits of the same vintage (early 1990s) did not have very good die cutting of the balsa parts.
__________________
'Til next time, Mike Toelle NAR 31692 L1 SAM 0373 |
Thread Tools | Search this Thread |
Display Modes | |
|
|