#1
|
|||
|
|||
Arapahoe-E CP?
So I finally dusted off the templates I bought from Gord years ago and had a crack at making one. I'm not sure I used the correct nose and tail cones - I used the V2 cones from BMS. I also tried a different paint scheme from the "standard" one. I've been flat chat trying to get a bunch of rockets ready for a high power launch (Thunda2) at Easter, so this has been a little side project. I kind of rushed it and the finish isn't amazing up close. The primer bled under my masking tape. Anyway, I like the effect and will probably attempt a better job of it another time.
In the meantime, would anyone know where the CP is for these? I just need to get my ballast installed so I can put a screw eye in the NC. |
#2
|
||||
|
||||
As per the RockSim file posted for the Thrustline Aerospace Arapahoe-E at rocketreviews.com CP: 19.9950 inches from the tip of the nosecone for BT-60 version (1.637" diameter) https://www.rocketreviews.com/unknown-arapahoe-e.html
__________________
Bruce S. Levison, NAR #69055 |
#3
|
|||
|
|||
Thanks Bruce!
|
Thread Tools | Search this Thread |
Display Modes | |
|
|