The nozzle/fin units are now finished. Although I like the look of chrome paint, it's use has been problematic. These were supposed to be a focal point of the model but now I just hope they blend in because I'm fed up with reworking the finish.
I cut some fiberglass window screen and used it to add detail to the top section. I thought about using metal screen but it fell apart when reduced to 1" x 1".

The artwork for the stickers is done and I have all the pieces for the recovery.
I need to come up with a launch lug system that I can attach with screws. I have a few ideas to try and will select the best one. So far this model has relied exclusively on mechanical fasteners as I have not found a glue that exhibits adequate bond strength for this plastic, especially for dissimilar materials.

Attached Thumbnails