Thread
:
3D printing for EVERYONE
View Single Post
#
52
07-01-2018, 08:31 PM
vcp
Intermediate Rocketeer
Join Date: Mar 2011
Posts: 90
A flickering tea light might be cool in that display stand.
There are two previous fin gluing guides on Thingiverse. They are both highly configurable (some OpenSCAD knowledge required), and they both position all fins at the same time. However they both use an 'in the tube' support, so they require that the fins must be placed before a motor mount is assembled.
https://www.thingiverse.com/thing:2298402
https://www.thingiverse.com/thing:26001
I don't think that I'd had these in my model rockets Thingiverse collections before, but they are there now.
https://www.thingiverse.com/garyacr...s/model-rockets
vcp
View Public Profile
Send a private message to vcp
Send email to vcp
Find all posts by vcp
Add vcp to Your Buddy List