OK, I finally finished up my backlog of custom projects so I can get back to this.

I worked out all of the patterns in CAD so those are ready and I've started a new prototype.

This can be done on the cheap but...

Now, the question is how do I proceed?

Do you guys want a full blown kit with laser cut parts, custom nose cones and details?

Or 1) a partial kit, body tubes balsa stock with fin patterns, parts list?

Or 2) a more complete partial kit, fin stock, patterns detail parts (just the guns), nose cone, decals parachute, Kevlar, etc. etc...

Or 3) just a plan set, material list and decals?

Keep in mind that a full blown kit would not be cheap, custom turned parts, and laser cutting cost and that will take time too.

Attached Thumbnails

 

__________________
"I'm a sandman. I've never killed anyone. I terminate runners when their time is up." Logan from "Logan's Run"

http://sandmandecals.com/