03-31-2018, 05:57 PM
|
|
Master Modeler
|
|
Join Date: Jan 2009
Location: Fairbanks, Alaska
Posts: 6,507
|
|
Quote:
Originally Posted by the mole
If I'm not mistaken eRocket is working on making a kit of this glider.
|
I certainly hope so! If answering this wouldn't betray any confidences, will it be a true "Repro-Retro" kit that uses the #7 (ST-7, 0.759" Outside Diameter) Centuri tubing and a balsa duplicate of the Centuri PNC-70 nose cone? Such a kit could use not only 18 mm motors, but also 13 mm mini motors (in a streamer-recovered motor adapter mount). Also:
It might be possible to minimize or even eliminate the backward loop (which occurs under power, after launch) by using a 13 mm motor adapter mount whose #5/BT-5 mini motor mount tube is located off-center by using suitably-punched (or laser-cut) flat fiber centering discs. (The rear-ejected, streamer-recovered motor mount of the Centuri Space Shuttle kit [it can be seen here: http://www.ninfinger.org/rockets/no...a/72cen044.html ] had such an off-center motor mount tube.) Installing such a 13 mm motor adapter mount in the Hummingbird with the motor mount tube on the "bottom" would lower the motor's thrust line (the adapter discs could even have their motor mount tube holes arranged to give a slightly "pitch down" thrust vector, if desired) and could prevent the backward loop under power (the Jetex, Jet-X, and Rapier model jets used/use similar thrust line pointing for the same reason).
|